Fortinet FCSS - Network Security 7.4 Support Engineer FCSS_NST_SE-7.4 Exam Dumps: Updated Questions & Answers (October 2025)

The advertised prefix of 10.20.30.0'24 was configured using the network command.

The first four prefixes are being advertised using a legacy route advertisement.

The advertised prefix of 10.20.30.0'24 is being advertised through the redistribution of another routing protocol.

The output shows all prefixes advertised by all neighbors as well as the local router.

Protocol options allow administrators to configure a maximum number of sessions for each configured protocol.

Protocol options give administrators a streamlined method to instruct FortiGate to block all sessions corresponding to disabled protocols.

Protocol options allow administrators to configure the Any setting for all enabled protocols, which provides the most efficient use of system resources.

Protocol options allow administrators to configure which Layer 4 port numbers map to upper-layer protocols, such as HTTP, SMTP, FTP, and so on.

The TCP port 445 is blocked between FortiGate and collector agent.

The collector agent preshared password is mismatched.

The FortiGate cannot resolve the active directory server name.

The FortiGate and the collector agent are using different TCP ports.

FortiGate will drop the expected traffic if it does not arrive within 23 seconds.

Clearing the master session has no impact on the expectation session.

This is a pinhole session to allow traffic for a TCP protocol that dynamically assigns TCP ports.

The session is checked against firewall policy ID 25.

The network type connecting the local Fortigate and OSPF neighbor 0.0.0.10 is point-to-point.

All neighbors are in area 0.0.0.0.

The local FortiGate is the BDR.

The local FortiGate is not a DROther.

Active Directory is used for authentication.

The authentication request is for an SSL VPN connection.

The IdP IP address is 10.1.10.254.

The IdP IP address is 10.1.10.2.

The TCP session has been successfully established.

The session was initiated from an authenticated user.

The session is being inspected using flow inspection.

The session is being offloaded.

Check whether TCP port 179 is blocked.

Check if there is an active static route to the peer.

Check whether both peers have an IP address within the same subnet.

Check if IP protocol 89 is blocked.

The Hello packet is being sent from an OSPF router with ID 0.0.0.112.

The two FortiGate devices attempting adjacency are in area 0.0.0.0.

One FortiGate device is configured to require authentication, while the other is not.

The passwords on the FortiGate devices do not match.

FortiTelemetry and Neighbor Discovery both operate using TCP.

The default port for Neighbor Discovery can be modified.

FortiTelemetry must be manually enabled on the FortiGate interface.

By default, the downstream FortiGate establishes a connection with the upstream FortiGate using TCP port 8013.