What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)
Refer to the exhibit.
Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
Refer to the Exhibits:
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
Refer to the exhibit.
Which statement explains the output shown in the exhibit?
Refer to the exhibit.
The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured packet loss will make T_INET_1_0 the new preferred member?
Exhibit.
The exhibit shows VPN event logs on FortiGate. In the output shown in the exhibit, which statement is true?
Refer to the exhibit.
Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true? (Choose two.)
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.
If port2 is detected dead by FortiGate, what is the expected behavior?
Refer to the exhibit.
An administrator used the SD-WAN overlay template to prepare an IPsec configuration for a hub-and-spoke SD-WAN topology. The exhibit shows the installation preview for one FortiGate device. In the exhibit, which statement best describes the configuration applied to the FortiGate device?