Symantec Administration of Symantec PacketShaper 11.9.1 250-440 Exam Dumps: Updated Questions & Answers (October 2025)

The Default bucket

TCPDiscovered_PoH_123

Any class with an IP address

HTTP which was auto-discovered

Inbound/Local host

inbound/Entertainment

Inbound/HTTP/Default

Inbound/HTTP/Entertainment

Inbound/Humor_jotes

To enable a traffic class to access unused bandwidth at Priority 3 or above

When a limit is specified that is less than the policy's guaranteed rate

When a limit is specified that is greater than the policy's guaranteed rate

To enable a traffic class to access unused bandwidth at a specified priority level

Output from the setup show command to determine the PacketShaper's configuration limits

An ASCII fie saved in the 9.256/cmd directory

Output from the trafficflow command to see how many concurrent flows of a specific type are present

Output from the ver ver command, which isdivided into non-sharable and sharable settings

When the associated traffic is UDP and conforms to recognized transaction behavior

When a network is unreliable or unstable more than 50% of the time

When network retransmission rates are close to zero

When the associated traffic is TCP and conforms to recognized transaction behavior

As Localhost

As Default

As Sameside traffic

As HTTP unknown

All traffic marked with the VIAN ID is classified by the exception class

An error occurs; classes that use VIAN IDs as criteria cannot be set as exception classes

All traffic marked with the VIAN ID is assigned a new priority level

Nothing occurs; PacketShaper does not intercept VIAN traffic

It is a short string describing the physical location of the host where the server is running.

It is the part of an SNMP public password referring to the physical location where the server is running.

It is a string encoding routing and NAT information to enable SNMP packets to reach the host from other subnets.

It is a path on an SNMP host to distinguish between many agents that may be running on that host.

You can apply any supported partitions and policies from the Sky UI

You can apply any supported partition from the Sky UI, but you must apply policies from the Advanced UI

You cannot apply them from the Sky Ul, you must use the Advanced UI to apply policies and partitions

You can apply static or dynamic partitions, but not burstable ones from the Sky UI

Go to - Sky UI > Resets Page

Go to - Advanced UI > Resets Page

Go to - Sky UI Unit > Resets Page

Go to- Advanced Ul > Unit Resets Page