Halloween Special Sale - 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: best70

Page: 1 / 2
Total 14 questions
Exam Code: FCP_FGT_AD-7.6                Update: Oct 31, 2025
Exam Name: FortiGate 7.6 Administrator FCP_FGT_AD-7.6

Fortinet FortiGate 7.6 Administrator FCP_FGT_AD-7.6 FCP_FGT_AD-7.6 Exam Dumps: Updated Questions & Answers (October 2025)

Question # 1

Refer to the exhibits.

Based on the current HA status, an administrator updates the override and priority parameters on HQ-NGFW-1 and HQ-NGFW-2 as shown in the exhibit.

What would be the expected outcome in the HA cluster?

A.

HQ-NGFW-1 will synchronize the override disable setting with HQ-NGFW-2.

B.

HQ-NGFW-2 will take over as the primary because it has the override enable setting and higher priority than HQ-NGFW-1.

C.

HQ-NGFW-1 will remain the primary because HQ-NGFW-2 has lower priority.

D.

The HA cluster will become out of sync because the override setting must match on all HA members.

Question # 2

You have configured an application control profile, set peer-to-peer traffic to Block under the Categories tab, and applied it to the firewall policy. However, your peer-to-peer traffic on known ports is passing through the FortiGate without being blocked.

What FortiGate settings should you check to resolve this issue?

A.

FortiGuard category ratings

B.

Application and Filter Overrides

C.

Network Protocol Enforcement

D.

Replacement Messages for UDP-based Applications

Question # 3

A remote user reports slow SSL VPN performance and frequent disconnections. The user is located in an area with poor internet connectivity.

What setting should the administrator adjust to improve the user's experience?

A.

Enable split tunneling to reduce VPN traffic.

B.

Change the SSL VPN port to a non-standard port.

C.

Increase the session timeout for inactive sessions.

D.

Configure the DTLS timeout to accommodate high-latency connections.

Question # 4

Which two statements about equal-cost multi-path (ECMP) configuration on FortiGate are true? (Choose two.)

A.

If SD-WAN is disabled, you can configure the parameter v4-ecmp-mode to volume-based.

B.

If SD-WAN is enabled, you can configure routes with unequal distance and priority values to be part of ECMP.

C.

If SD-WAN is disabled, you configure the load balancing algorithm in config system settings.

D.

If SD-WAN is enabled, you control the load balancing algorithm with the parameter load-balance-mode.

Question # 5

Refer to the exhibit, which shows an SD-WAN zone configuration on the FortiGate GUI.

Based on the exhibit, which statement is true?

A.

The Underlay zone is the zone by default.

B.

The Underlay zone contains no member.

C.

port2 and port3 are not assigned to a zone.

D.

The virtual-wan-link and overlay zones can be deleted.

Question # 6

An administrator wanted to configure an IPS sensor to block traffic that triggers a signature set number of times during a specific time period.

How can the administrator achieve the objective?

A.

Use IPS group signatures, set rate-mode 60.

B.

Use IPS packet logging option with periodical filter option.

C.

Use IPS filter, rate-mode periodical option.

D.

Use IPS filter, rate-mode periodical option.

Question # 7

Refer to the exhibit.

The predefined deep-inspection and custom-deep-inspection profiles exclude some web categories from SSL inspection, as shown in the exhibit.

For which two reasons are these web categories exempted? (Choose two.)

A.

The FortiGate temporary certificate denies the browser’s access to websites that use HTTP Strict Transport Security.

B.

These websites are in an allowlist of reputable domain names maintained by FortiGuard.

C.

The resources utilization is optimized because these websites are in the trusted domain list on FortiGate.

D.

The legal regulation aims to prioritize user privacy and protect sensitive information for these websites.

Question # 8

Refer to the exhibits.

An administrator wants to add HQ-ISFW-2 in the Security Fabric. HQ-ISFW-2 is in the same subnet as HQ-ISFW. After configuring the Security Fabric settings on HQ-ISFW-2, the status stays Pending.

What can be the two possible reasons? (Choose two.)

A.

Upstream FortiGate IP must be set to 10.0.11.254.

B.

SAML Single Sign-On must be set to Manual.

C.

HQ-ISFW-2 must be authorized on HQ-ISFW.

D.

Management IP must be set to 10.0.13.254.

Question # 9

You have created a web filter profile named restrict_media-profile with a daily category usage quota.

When you are adding the profile to the firewall policy, the restrict_media-profile is not listed in the available web profile drop down.

What could be the reason?

A.

The firewall policy is in no-inspection mode instead of deep-inspection.

B.

The inspection mode in the firewall policy is not matching with web filter profile feature set.

C.

The web filter profile is already referenced in another firewall policy.

D.

The naming convention used in the web filter profile is restricting it in the firewall policy.

Question # 10

Refer to the exhibits.

You have implemented the application sensor and the corresponding firewall policy as shown in the exhibits.

Which two factors can you observe from these configurations? (Choose two.)

A.

YouTube search is allowed based on the Google Application and Filter override settings.

B.

YouTube access is blocked based on Excessive-Bandwidth Application and Filter override settings.

C.

Facebook access is allowed but you cannot play Facebook videos based on Video/Audio category filter settings.

D.

Facebook access is blocked based on the category filter settings.

Page: 1 / 2
Total 14 questions

Most Popular Certification Exams

Payment

       

Contact us

dumpscollection live chat

Site Secure

mcafee secure

TESTED 31 Oct 2025